Information For Your Safety; How To Use - LG V-CQ3 H Series Quick Start Manual

E

Information for your safety

Please read all the following information,
which contains important instructions for
the safety, the use and the maintenance
of the appliance.
This appliance complies with the following
EC Directives: -73/23/EEC, 93/68/EEC-
Low Voltage Directive-89/336EEC -EMC
Directive.
Never allow children to use the appliance
unsupervised.
Do not use the appliance If the main lead
is damaged or faulty.
If the main lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent to avoid a hazard.
Always switch the vacuum cleaner off
before :
• changing the dust bag
• changing or cleaning the filters.
If no dustbag is inserted, the cover
cannot be closed. Please do not use
force!
Do not vacuum flammable or explosive
substances(liquids or gases).
Do not vacuum hot ash, embers etc. nor
sharp objects.
Do not vacuum water or other liquids.
When you vacuum with an attachment
appliance that has a rotating brush roller,
do not reach into the running brush roller.
WARNING! Should it become necessary to
replace the moulded on plug then the
detective plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13
amp socket elsewhere in the house.

How to Use

Connecting the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button (3)
situated on the head, then pull upwards.
Assembling the tubes
• Telescopic tube (4)
- Hold spring latch (5)
- Pull out the tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Fit the large cleaning head onto the end of the
tube.
• The 2 position head (6) is equipped with a
pedal (7) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position(tiles, parquet
floors...). Press on the pedal to lower the
brush. Carpet or rug position. Press on
the pedal to lift the brush up.
Dust bag storage(8)
Dust bag storage(8) can easily lay up the
new dust bag.
It prevent dust bag from missing.
How to plug in and use
Pull out the mains lead to the desired
length and plug into the socket.
Slide button (9) to start the vacuum
cleaner. To stop it slide the button (9)
again.
Electronic power control(9)
Suction capacity increases steplessly up
to MAX.
OFF : Power off
FLOOR : Full power.
Urethane Wheel(10), (11)
The three urethane wheel of stairs(10)
and urethane wheel(11) prevent a scratch
on the floor.
They reduce the rolling noise.
LED Display (13)
YELLOW: Power on
Park-System (14)
For short breaks during vacuuming, for
example to move a small piece of
furniture or a rug, use the Park system to
– 4 –
CURTAIN : Low
RED: Bag Full