Replacing The Sprocket; Storing The Tool - Makita DUC204 Instruction Manual

2. Remove the small dust or particles using
a slotted screwdriver with a slender shaft or the
like.
► 1. Slotted screwdriver 2. Oil discharge hole
3.
Insert the battery cartridge into the tool. Pull
the switch trigger to flow built-up dust or particles
off the oil discharge hole by discharging chain
oil.
4.
Remove the battery cartridge from the tool.
Reinstall the sprocket cover and saw chain on
the tool.

Replacing the sprocket

CAUTION: A worn sprocket will dam-
age a new saw chain. Have the sprocket
replaced in this case.
Before fitting a new saw chain, check the condi-
tion of the sprocket.
1
► 1. Sprocket 2. Areas to be worn out
2
2
Always fit a new locking ring when replacing the
sprocket.
1
► 1. Locking ring 2. Sprocket
NOTICE: Make sure that the sprocket is
installed as shown in the figure.

Storing the tool

1. Clean the tool before storing. Remove any
chips and sawdust from the tool after removing
the sprocket cover.
2. After cleaning the tool, run it under no load
to lubricate the saw chain and guide bar.
3. Cover the guide bar with the guide bar
cover.
4. Empty the oil tank.
19 ENGLISH
2
1