Replacing The Sprocket; Storing The Tool; Instructions For Periodic Maintenance - Makita DUC204 Instruction Manual

2. Remove the small dust or particles using a slotted
screwdriver with a slender shaft or the like.
1. Slotted screwdriver 2. Oil discharge hole
3. Insert the battery cartridge into the tool. Pull the
discharge hole by discharging chain oil.
4. Remove the battery cartridge from the tool.
Reinstall the sprocket cover and saw chain on the tool.

Replacing the sprocket

CAUTION:
A worn sprocket will damage a
new saw chain. Have the sprocket replaced in this
case.
the sprocket.
1
1. Sprocket 2. Areas to be worn out

Instructions for periodic maintenance

be performed regularly. Warranty claims can be recognized only if this work is performed regularly and properly. Failure to
work which is not described in the instruction manual. All such work must be carried out by our authorized service center.
Check item / Operating time
Chain saw Inspection.
Cleaning.
Check at
authorized
service center.
2
2
Before Everyday
operation
-
-
sprocket.
1
1. Locking ring 2. Sprocket
NOTICE:
Make sure that the sprocket is installed

Storing the tool

1. Clean the tool before storing. Remove any chips
and sawdust from the tool after removing the sprocket
cover.
2. After cleaning the tool, run it under no load to lubri-
cate the saw chain and guide bar.
3. Cover the guide bar with the guide bar cover.
4. Empty the oil tank.
Every week
- -
-
- -
18 ENGLISH
2
1
Every 3 Annually
month
- -
- -
-
Before
storage
-
-