☐
Cut the loop of grey wire from the black module on DTC main harness (Figure 61).
Route the following wires into the engine compartment via a grommet in the
firewall*:
☐
*White 16 AWG wire with bullet connector from the control module (clutch
wire).
☐
*Grey cable with the green connector from the control module (temperature
sensor).
☐
*Red wire from the control module (constant power). Cover all of the engine
compartment wires with plastic loom.
Engine Bay Connections
☐
Route the grey cable and white wire running from the control module along the
OEM wiring harness, and around the degas bottle.
☐
Crimp the supplied fuse holder to the red wire running from the control module.
Ensure the fuse holder is installed as close to the power source as possible.
☐
Connect the other end of the fuse holder to the positive battery terminal.
☐
Connect the green connector on the grey cable to the matching connector on
the compressor.
☐
Connect the bullet connector on the white wire to the matching connector on
the compressor.
☐
Connect the 2 pin connector on the pressure switch harness into the pressure
switch.
☐
Connect the ring terminal on the green wire with yellow stripe to a good ground.
☐
Route the grey 18 AWG wire to the WHASP Tank.
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
Cut loop
Figure 61 — Disable pull up harness
49