2.5.2 Connecting Low Dc Power - Siemens SIMATIC NET RUGGEDCOM RX1510 Installation Manual

Installing the Device
2.5.2 Connecting Low DC Power
6.
7.
2.5.2 Connecting Low DC Power
To connect a low DC power supply to the device, do the following:
Electrical hazard – risk of damage to equipment
Do not connect AC power cables to a 12, 24 or 48 VDC power supply terminal block.
Damage to the power supply may occur.
Note
The RUGGEDCOM RX1510 works with both positive VDC power supplies and negative
VDC power supplies.
14
Using a #10 ring lug and #10-32 screw, secure the ground terminal on the
power source to the ground connection on the device. Make sure the lug is
tightened to 1.1 N·m (9.5 lbf·in).
1
2
#10 Ring Lug
1
#10-32 Screw
2
Connection from External Power Source
3
Ground Connection
4
Figure 2.7 Ground Connection
Install the safety cover over the terminal block.
NOTICE
3
4
Installation Manual, 04/2021, C79000-G8976-1055-20
RUGGEDCOM RX1510