Advertisement
9. FILTER CLEANING FIG.7
9.1.
Handle the filter carefully when cleaning or installing. Unlock and carefully remove the cartridge filter and inspect it for damage. A filter
that has small holes or tears in it will not perform efficiently and should be replaced.
9.2.
To clean a dry filter, tap it inside a waste bin. (The cartridge filter is designed for dry vacuuming only). Should the filter be inadvertently
wetted it should be rinsed from the inside and allowed to air dry for 24 hours.
DO NOT use the filter wet as the filter will clog quickly and be very difficult to clean.
8
9.3.
Fit a new/cleaned filter over the filter basket
9.4.
Lock in place as described in 7.1.2. (0mm clearance).
fig.7
10. MAINTENANCE
10.1.
Ensure the machine is unplugged from the power supply.
10.2.
Disconnect the hose from the drum container.
10.3.
Undo the clasps and remove motor housing from the drum container.
10.4.
Clear out any dirt or debris from the drum container and hoses. Frequently clean the seat where the safety float slides and periodically
inspect it to check its integrity.
10.5.
Clean the foam filter by washing it in a mild soapy solution.
10.6.
Check the power cable to make sure that it is not damaged.
11. TROUBLESHOOTING
Symptom
Vacuum will not operate
Dust expelled from the motor cover
Reduced efficiency and increased motor/
speed vibration/orange light (C)
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Possible causes
No power supply
Faulty power cable
Container full
Cartridge filter missing or damaged
There is a blockage in the nozzle/hose/
drum inlet/ filter.
01284 703534
sales@sealey.co.uk
Original Language Version
Solutions
Check power supply - cable, breakers, fuses
Unplug and check the power cable. If damaged have it
replaced by your local Sealey stockist.
Empty container
Fit cartridge filter or replace damaged filter
See 7.1.4. Check nozzle, hose and container inlets and
clear any blockages found. Remove filter and clean it or
install new filter.
www.sealey.co.uk
DFS35M Issue 4 14/07/2020
Advertisement
