Makita GA003G Instruction Manual page 12

When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
For 115 mm (4 - 1/2") / 125 mm (5")
model
When installing the abrasive cut-off wheel:
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
mm (5/32")) 3. Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange
When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
1 1
2 3
4
4
1 1
2 3
4 4
1 1
2 3
4 4
Installing wire cup brush
Optional accessory
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
► 1. Wire cup brush
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench.
Installing wire wheel brush
Optional accessory
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
► 1. Wire wheel brush
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrenches.
12 ENGLISH
1
1