Advertisement
In the event of a power loss the switch can remember the relay positions for when the
power has been restored, please send the text as follows
#RELMEM=ON#
#RELMEM=OFF#
The default setting is Relay Memory OFF
It is possible to obtain a relay state report at any time. This will give you the position of the
relays. To do this you will need to send a text.
The unit has a "sim active" function which monitors the activity on the simcard. If it has
been inactive for 6 weeks, it will send an automatic text to a pre-recorded number. This will
then eliminate the problem of your sim getting shut down if they are unused for 3 months.
New SIM cards will need registering before they can be used. Full details of how this is
done can normally be found in the SIM card pack. It will normally require that the SIM card
is inserted into a mobile phone, a number dialled and instructions followed. While the SIM
is in the mobile phone it would be a good time to disable any PIN codes, call diverts, ring
back and disable features such as voicemail and text alerts. Details of how to do this can
be found on the SIM card provider's web site or by calling their customer services. Please
use one of the following SIM card providers - Vodafone, TMobile, O2 or Orange.
Note
RELAY STATE REPORT IS THE STATUS OF BOTH RELAYS i.e.
Relay Memory
The unit will remember relay status in event of power failure
The unit will not remember relay status and power on with both relays
set to off
Status Report
Please Note
Currently not suitable with the network provider "three"
QUICK PROGRAMMING COMMANDS
REL 1 OFF = REL 2 OFF
REL 1 ON
REL 1 OFF = REL 2 ON
REL 1 ON
#REL=STATE#
=
REL 2 OFF
= REL 2 ON
Page 6
Advertisement
