Advertisement
Once the unit has a
dipswitch 2 to ON so only authorised numbers you store can activate the unit. If dipswitch
2 is left OFF anyone phoning the units number can operate the relays.
If you do not require authorised users please skip to the next page
To program a number to the caller ID (whl) list you will need to send a text message code:
#WHL#NUMBER#
To delete the number send a text message code:
#DEL#NUMBER#
Example
#WHL#07123456789#
Example
#DEL#07123456789#
If the code is accepted the unit will reply "WHL number stored" or "WHL number deleted"
Once the numbers have been programmed please set dispwitch 2 to ON position
YOU CAN ONLY SEND ONE NUMBER AT A TIME. PLEASE SEND THE MESSAGE
AND WAIT FOR THE 2G/3G MULTI SWITCH TO SEND YOU BACK A TEXT
ACKNOWLEDGEMENT "STORED" BEFORE YOU TRY TO ADD ANOTHER NUMBER
Please make sure you have credit on your simcard to receive the text acknowledgment.
It may take some time to receive text acknowledgements depending upon how busy
your telephone network is at the time.
For a quick reset and to clear all numbers there is a built in reset function that is triggered
via sending an sms/text message.
Send a text message (#reset#) to the unit
The unit will then remove all WHL numbers stored.
Please only do this if you really have to.
How to program the Multi Function Switch
green
light it is ready to be used. The unit can be set by switching
PLEASE NOT
HOW TO USE THE MULTI FUNCTION SWITCH
to store you mobile number. (Maximum 60 users)
to delete mobile number.
PLEASE NOTE
VIA TEXT ENTRY
Reset Function
Page 4
Advertisement
