ESPRIT 1. Introduction............................5 1.1 Introduction and purpose of the Manual ..................5 1.1.1 Use of this Manual ........................5 1.2 Warranty conditions ........................5 1.3 Graphical conventions ........................5 1.4 Personnel qualifications ......................... 6 1.5 General warnings ........................... 6 1.5.1 To be arranged by the Customer ....................
Page 4
ESPRIT 4.7.1 Starting: ..........................27 4.7.2 Setting ............................ 27 4.8 Idle time and restarting ........................ 27 5. Instructions for use..........................28 5.1 Correct use of the cabinet ......................28 5.2 Uses to be avoided ........................28 5.3 Working limits ..........................29 5.4 Cabinet control functions ......................
1. Introduction 1.1 Introduction and purpose of the Manual Thank you for choosing Criocabin S.p.a., hereinafter referred to as the Manufacturer. We are glad to have you as our Customer and hope you will be fully satisfied with this product.
ESPRIT within the illustration. Illustration references and component references may be used at the same time (i.e. A - Fig. 1 or 1 - Fig. 1). The following graphical symbols are used in this Manual to draw users’ attention to information...
ESPRIT Note! It is strictly forbidden to use them to carry out modifications on the product. Possible modifications are to be required directly to the Dealer, specifying all the product technical features and the reasons for such modifications; if approved, modifications must be carried out only by the Manufacturer’s personnel or by authorised personnel.
ESPRIT 2. Information on safety 2.1 General regulations - Training • It is recommended that any person who interacts with the product reads this Manual completely before starting to operate. • Negligence or failure to comply with these safety regulations while using and maintaining the product may cause accidents for which the Dealer and the Manufacturer are not responsible.
Page 9
ESPRIT Warning! If a refrigerant fluid comes into contact with eyes: do not rub the eyes; remove contact lens; rinse thoroughly for at least 20 minutes. If a lubricant comes into contact with skin: wash the skin with a great quantity of water for at least 20 minutes;...
ESPRIT 3.2 Technical characteristics In this manual all dimensions in the technical drawings are given in millimeters (mm). 3.2.1 Dimensions Fig. 1 Dimensions Esprit 200...
ESPRIT 3.2.4 Admissible loads As for the cabinet admissible loads, refer to the following table: COMPONENTS LOAD Top canopies, alluminium max kg 20/m Top canopies, glass max kg 8/m Intermediate shelves max kg 8/m Display surfaces max kg 95/m 3.2.5 Refrigeration system: As for the refrigerant fluid characteristics, refer to the enclosed "Refrigerant fluid R404a safety...
ESPRIT 3.5 Environmental requirements for operation To maintain the refrigerating cabinet in good working conditions check that the cabinet temperature class corresponds to that of the room where the cabinet has been installed (see rating plate). To maintain in good conditions cabinets provided with a refrigerating unit, act as follows: •...
ESPRIT Warning! DANGER OF CRUSHING Cabinet front glasses open by means of piston system. Pistons act as a lifting back-up and prevent the glass from accidental and unexpected falling. To avoid danger of crushing, check periodically the system efficiency and check if the ef- fort required to lift the glass is increasing, as this will indicate a reduced efficiency of the lifting system.
ESPRIT 4. Instructions for commissioning 4.1 Transport, handling and positioning 4.1.1 Precautions to be taken upon receipt of the product The Manufacturer supplies the cabinet ex-works. Before delivery to the carrier, the material, subject matter of the supply contract, shall be carefully inspected by the Manufacturer.
To handle the cabinet use a forklift truck of suitable capacity. Refer to the gripping-lifting areas shown in the picture below. As for the weight of the cabinet, refer to “3.2 Technical characteristics” on page 11. Fig. 3 Handling ESPRIT Note! It is recommended to move the cabinet only by means of a pallet.
ESPRIT In case of cabinets provided with a condensate collection tank, make sure that the collection tank has been positioned so that to allow the connection of the relative drainage pipe to the hydraulic system. 4.2 Unpacking and disposal of packaging materials Unless otherwise specified, the Customer is responsible for the operations mentioned below.
Page 19
ESPRIT C60001080 SILICONE Fig. 5 Ducting first phase a) Place the two cabinets side by side (1) b) Apply the supplied adhesive sponge on the kit along the section of the tank (1)
Page 20
ESPRIT ]c) Apply a great quantity of silicon above the sponge just applied so as to reduce the entrance of the air (2) LIVELLA Fig. 6 Ducting second phase a) Connect the two cabinets (3) b) Check the correct line up between the cabinets with the bubble (4)
Page 21
ESPRIT RIF. 3 C50006050 RIF. 3 C50001880 Fig. 7 Ducting third phase a) Take out the display decks and the front panels (only those which coincide) of the side which has to be multiplexed and the air suction grids (5) b) Fix the screw on the front support of the cabinet REF.1 C50001040 SCREW M6X100 TE IX + REF.2...
Page 22
ESPRIT RIF. 1 C50001040 RIF. 3 C50001880 RIF. 4 C50013700 RIF. 4 C50013690 Fig. 8 Ducting fourth phase a) Fix the screw in the backside of the cabinet REF.3 C50006050 SCREW M6 X 30 TCEI ZN+ REF.2 C50001880 DADO M6 ZN (7)
Page 23
Fix the screws in the inner of the tank in the positions shown in the picture REF.1 C50001040 SCREW M6X100 TE IX + REF.2 C50001880 DADO M6 ZN (8) c) Fix the supports to each other applying RIF.4 VITE CANNOCCHIALE MAS M5X24 TCI NICH.L + RIF.5 VITE CANNOCCHIALE FEM. M5X24 TCI NICH.L (9) MULTIPLEXING WITH OTHER ESPRIT MODELS...
Page 24
ESPRIT RIF.7 C50008060 RIF.6 C50001730 Fig. 10 a) Combine the two banks (11) b) Remove the back panel covers (12)
Page 25
ESPRIT RIF.6 C50001730 RIF.7 C50008680 RIF.6 C50001730 RIF.7 C50008680 Fig. 11 a) Fix with RIF.6 C50001730 VITE AF 4,8X60 TC -IC IX + RIF.7 C50008060 RONDELLA D. 6,4X12 IX (13) (14)
ESPRIT 4.4 Disassembly and subsequent reassembly The Customer is responsible for the cabinet disassembly in order to move it and for its subsequent reassembly. For technical service, the Customer can apply to the Reseller. 4.5 Fixing The cabinet described in this manual is provided with screw feet and therefore does not need to be fixed to the floor.
ESPRIT 4.6.3 Connection to the drain line The cabinet must be connected to a drain line if it is not provided with tanks collecting the condensate coming from inside the cabinet tank. In this case, connect the condensate drainage pipe to the drain line of the place where the cabinet has been installed.
ESPRIT 5. Instructions for use the Customer is responsible for the operations mentioned below. 5.1 Correct use of the cabinet Note! When using the cabinet we recommend to observe with the utmost scrupulousness the principles of the Hazard Analysis and Critical Control Point (Haccp) concerning: personal hygiene of all the operators of food service;...
ESPRIT 5.3 Working limits Refer to the enclosed "Carel control unit instructions for use". 5.4 Cabinet control functions Here are the cabinet control functions reckoned among the Customer’s common skills: • cabinet switching on; • manual defrosting of the evaporator;...
ESPRIT 6. Maintenance instructions 6.1 General warnings Maintenance operations described in this manual concern planned routine maintenance. The Customer is responsible for the routine maintenance of the equipment. Special maintenance shall be carried out only by qualified personnel according to what stated in the "Maintenance Manual", which is not an integral part of this manual.
ESPRIT 6.3 Bulb replacing To replace bulbs act as follows: 1) unplug the cabinet from the mains or open the main switch; 2) remove the plastic guard; 3) hold the defective bulb at both ends; 4) turn the bulb 90° until you hear a slight click;...
ESPRIT 7. Instructions for demolition and disposal Make sure that all parts of the cabinet are disposed of in compliance with the laws in force in the User’s country. Pay particular attention to the following list of materials used to produce the cabinet and entrust their recovery and/or disposal to specialized and authorized companies: •...
ESPRIT 8. Parameter table of control panel 8.1 List of parameters TYPE MIN MAX U.M. Def. PROBE PARAMETERS Probe measurement stability Virtual probe Probe display on the display unit Probe display on the terminal unit Selection °C or °F degrees...
Page 34
ESPRIT TYPE MIN MAX U.M. Def. Display during defrost: flag Alarm delay after defrost or door opening hours 1 Defrost priority on compressor time flag Dripping time Interval between defrost cycles Max./real defrost duration End defrost temperature °C/°F 4 FAN PARAMETERS...
Page 35
ESPRIT TYPE MIN MAX U.M. Def. Temperature setpoint °C/°F -100 4 HACCP - HA - HF alarm reset flag...
ESPRIT 9. Attachments 9.1 Reference to manuals of other suppliers Instructions of control unit CAREL: as attached Wiring diagram: attahed. 9.2 Declaration of conformity: as attached...
Need help?
Do you have a question about the ESPRIT and is the answer not in the manual?
Questions and answers