— 05
Assembly & disassembly on the board.
TAAROA masts are mounted on the board by a mounting box system. Different
— 01
types of mounting boxes are available to adapt to the board mounting systems :
KITEFOIL
— RANGE
WINDFOIL
— RANGE
By steps :
— 02
—
Assemble
the foil on
the board
—
To
Disassemble
the foil
EN
Min i Pro B ox
D e e p Tuttle
1
For the Plate Mount only: mount the mast to the Plate Mount by using the 3 M6x30mm Torx
screws. The Tuttle, Power Box and Mini Pro Box mounts are already affixed to the mast. Lay the
board upside down (hull up).
2
Insert the heel of the foil, already mounted onto the mast box provided, in the hull or align
the rails of the board in the case of a Plate Mount.
3
In the case of a Tuttle, Power Box or mini Pro Box, tilt the board on the edge and carefully
drive it inside the board mounting box.
4
Tighten the M6x55mm screws for the Windfoil range and M8x40mm screws for the Kite-
foil range with a TORX key, remembering to place the 18mm rubber washers. Lay the board
upside down (hull up).
1
Place the board + foil upside down (hull up).
2
Disassemble the wings and fuselage.
3
Tilt the board on its edge to unscrew the screws attaching the board to the mast box
(Power Box, Tuttle Box, mini Pro Box); or unscrew with the board upside down in the case of
a plate mount.
Plate Mount
Powe r B ox
8