Table of Contents
Advertisement
Physical Features
D
C
B
A
W * Warning
Never look directly into optical
output connectors (B and D).
Some sources produce
invisible radiation that can
permanently damage your
eyes.
A
Button for activating the visual fault locator (B) and output port (D). See
E
"Using the Visual Fault Locator" on page 33 and "Autotest in Far End Source
Mode" on page 28.
B
Universal fiber connector (with dust cap) for the visual fault locator output.
The connector accepts 2.5 mm ferrules. The LED below the connector
indicates the locator's mode (continuous or blinking).
C
SC input connector with dust cap. Receives optical signals for loss, length,
and power measurements.
D
amd64f.eps
SC output connector with dust cap. Transmits optical signals for loss and
length measurements.
The LED below the connector is red when the output is transmitting the
module's shorter wavelength, and green for the longer wavelength.
E
Laser safety label (shown at right).
Figure 2. Fiber Module Features
Getting Acquainted
amd128i.eps
7
Advertisement
Table of Contents
