Subscribe to Our Youtube Channel
Related Manuals for Satel INT-SZ
Summary of Contents for Satel INT-SZ
- Page 1 INT-SZ Code lock Firmware version 2.02 int-sz_en 08/20 SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND tel. +48 58 320 94 00 www.satel.eu...
- Page 2 Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty. SATEL aims to continually improve the quality of its products, which may result in changes in their technical specifications and software. Current information about the changes being introduced is available on our website.
-
Page 3: Table Of Contents
CONTENTS Features ........................... 2 Installation ........................2 Address setting ......................3 Description of terminals ....................4 Configuring ........................4 Description of parameters and options ............... 4 Using ..........................7 LED indicators ......................7 Sound signaling ......................7 4.2.1 Beeps generated when operating ................ 7 4.2.2 Signaling events .................... -
Page 4: Features
INT-SZ SATEL The INT-SZ code lock can control the access to a single door. The device can be used in conjunction with the INTEGRA and INTEGRA Plus control panels. The code lock is offered in two versions differing in key backlight color: INT-SZ-GR –... -
Page 5: Address Setting
12. Power on the alarm system. 13. Start the identification function in the control panel (see the control panel installer manual). The code lock will be identified as “INT-SZ/SZK”. 2.1 Address setting An individual address (different from that in the other devices connected to the control panel... -
Page 6: Description Of Terminals
INT-SZ SATEL To set the address, use the DIP switches on the electronics board. The switches have numbers assigned to them. The number for OFF position is 0. The numbers assigned to the switches in ON position are presented in the table 1. The sum of these numbers is the address set. - Page 7 SATEL INT-SZ Fixed ON time – OFF if door closed [ON, closeoff] – the relay output will be turned on until the door is closed (door status input is reconnected to common ground), however not longer than for the “Relay ON time”.
- Page 8 INT-SZ SATEL Dependent on door (1) / Dependent on door (2) – you can select the door that must be closed so that the user can get access (turn the relay output on). It allows you to create an airlock. You may select a door supervised by another expander or alarm system zone programmed as type “57 Technical –...
-
Page 9: Using
SATEL INT-SZ Auto – on for about 40 seconds after pressing any key. Additionally, it can be turned on if a specific event occurs (see the “Auto-backlight” parameter). Permanent – always on. Auto-backlight – if the keys backlight comes on automatically, you can additionally define whether and what event will turn the backlight on: No –... -
Page 10: Code
INT-SZ SATEL 5 short beeps – zone violation (CHIME). Very short beeps – door open too long. 4.3 Code Most of the functions are available after entering the code. By factory default, the following codes are programmed in the control panel:... - Page 11 SATEL INT-SZ Relay output (resistive load) ................. 1 A / 30 VDC Environmental class according to EN50130-5 ................. II Operating temperature range ................-10°C...+55°C Maximum humidity ......................93±3% Dimensions ....................80 x 127 x 24 mm Weight ..........................110 g...
Need help?
Do you have a question about the INT-SZ and is the answer not in the manual?
Questions and answers