Composite Sampling; Discrete Sampling - Global Water WS700 Manual

VII. Composite Sampling
A composite sample is a series of smaller samples put into the same bottle, thus showing
an "average" sample over time. Set the Interval control to the desired time between
samples (do not select the External Trigger position). Set the Size control to the desired
sample size. Note that the sample size settings are approximate and apply to a head height
of four feet. For heights other than four feet, refer to the chart inside the front of the
sampler.
The sampler starts timing when both of the optional Rain and Water Sensors detect
moisture. If you do not have the optional water sensors or do not need them for your
application, defeat them by plugging one of the two shorting plugs supplied with the sampler
into their jack. If both inputs are defeated, the sampler starts up triggered when the power
switch is turned on. The Status LED starts blinking every 2 seconds once the sampler is
triggered.
The Start Delay timer begins running when the sampler is triggered by the Rain and Water
Sensors and the first sample is taken when the timer expires. If the Delay control is set to
zero, sampling begins immediately. The delay timer only applies to the first sample taken,
except as described later in the section titled "External Trigger Mode". At the end of each
sample, the pump reverses for 15 seconds.
Sampling continues as Trigger-Delay-Sample-Reverse-Interval-Sample-Reverse-Interval-
Sample-Reverse ... until the sample bottle is full. When the bottle is full, the Status LED
remains lit constantly.
VIII. Discrete Sampling
A discrete sample is a single sample put into the same bottle, thus being a sample at one
point in time. Set the Sample Size control to "Full". Once started, the pump will continue to
run until the sample bottle if full.
As with composite sampling, the Start Delay timer begins when the sampler is trigger by the
Rain and Water Sensors and the first sample is taken when the timer expires. If the Delay
control is set to zero, sampling begins immediately. The Status LED blinks every 2 seconds
while the delay timer or the pump is running and remains lit constantly once the sample
bottle has been filled. At the end of sampling, the pump reverses for 15 seconds.
Global Water
800-876-1172 • globalw.com
- 8 -