• setzen Sie sich der Gefahr von Stromschlägen und anderen Verletzungen aus. • Ziehen Sie nicht am Kabel, knicken Sie es nicht und stellen Sie keine schweren Gegenstände darauf. • Fassen Sie den Stecker nicht mit nassen Händen an. • Stellen Sie keine Quellen off...
Page 4
Gebogenes Rohr (Ausgang) 13 Ein- und Ausgang Gebogenes Rohr (Eingang) Deckel Verbindungsstück Skimmer-Verbindungsstück Haupteinheit Sprüh-Rohr Eingangsrohr Leuchte Sprüh-Rohr-Abdeckung Eingangs-Abdeckung Abdeckung Drainagekorb Skimmer Saugnapf Drainagekorb Verbindungsstück Schläuche Keramikringe (optional) Aktivkohle (Optional) Biochemisch reakti- Bio-Kugeln (optional) ve Baumwolle Inbetriebnahme Wie in Abbildung 1 zu sehen, sollten zunächst die Verschluss-Schnallen (1 und 2) aufgeklappt werden, wodurch sich der Deckel vom Korpus löst.
Sobald die Wasserhöhe im Ausgangs-Rohr/-Schlauch der des Aquariums entspricht, können Sie das Gerät an Ihren Hausstrom anschließen. Unter der transparenten Abdeckung fi nden Sie den Ein-/Ausschalter (sowie, bei 10028066, den Schalter für die UV-Licht-Lampe. Das Leuchtmittel wechseln •...
220 - 240V / ~50Hz Electrical Power UV Lamp Power H-Max 2.5m Output 2000l/h Dimensions 290 x 290 x 485mm Article no. 10028066 Voltage 220 - 240V / 50Hz Electrical Power H-Max 2,0m Output 1400l/h Dimensions 258 x 258 x 430mm Important Safety Instructions •...
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. •...
Initial Use 1.According to the diagrammatic representation, the buckles (1)and(2) should be unfolded at fi rst,which will separate the main body and the lid.. Put the draning skeps with fi ltermedium into the mainbody in turn. Press the lid with your hands to connect the main body and the lid again.Then you should fasten the buckles (1) and (2) Pull the securing buckle to take out the input and output nozzle.
Replacing the UV Light Tube 1. Please open the lid from the main body carefully. Put the Iid in Inversion, loosen bolt and take the frame of the quartz tube out. Turn the quartz tube counterclockwise slowly. 2. Pull out the bad light tube. 3.