Frigidaire FAC106N7A1 Use & Care Manual page 9

Air Conditioner Features
(continued)
CHECK FILTER FEATURE:
CLEAN AIR FEATURE
DO THIS:
CLEAN AIR
BUTTON
REMOTE SENSING
FEATURE
(on some models)
DO THIS:
REMOTE SENSING
BUTTON ON
YOU WILL SEE:
: YOU WILL SEE:
(on some models)
PRESS
YOU WILL SEE:
:
PRESS
LIGHT On
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling. The LED (light) will illuminate after 250 hours of
operation. To reset after cleaning the filter, press the
"Check Filter" button and the light will go off..
LIGHT On
Note: When this feature is "ON," the electronic air purifier
is energized to remove pollen and impurities from the air.
To cancel this feature, press the Clean Air button (the LIGHT
will turn off).
Note: This feature can be activated on the unit touchpad
ONLY.
LIGHT pulsing On & Off intermittently.
Note: This feature can be activated from the remote control
ONLY.
To activate the remote sensing feature, point the remote
control towards the unit and press the remote sensing
button. The LIGHT on the unit control will pulse to indicate
it received the signal. The LIGHT on the remote control will
pulse each time it sends a signal. It will continue to send
this signal until the feature is deactivated by pressing the
remote sensing button. If the unit does not receive the
remote sensing signal during any 3 minute interval, the unit
will beep to indicate the remote sensing mode has ended.
The display on the remote control indicates the
temperature at the remote ONLY when the unit is in the
"Fan Only" mode. When the unit is in the "Cool" mode,
the display on the remote control indicates the set
temperature.
9