Table of Contents
Advertisement
Privileged Sessions Hardware
This document describes how to set up the One Identity Safeguard for Privileged Sessions
(SPS) hardware. Refer to the following documents for step-by-step instructions:
Safeguard Sessions Appliance 3000: see the SC113 Chassis Series User's Manual,
l
Chapter 6: Rack Installation, available online at
https://www.supermicro.com/manuals/chassis/1U/SC113.pdf.
Safeguard Sessions Appliance 3500: see the SuperServer 1029U-T Series User's
l
Manual, Chapter 2: Server Installation, available online at
https://www.supermicro.com/manuals/superserver/1U/MNL-1973.pdf.
For details on how to install a single SPS unit, see Installing the SPS hardware.
l
For details on how to install a two SPS units in high availability mode, see Installing
l
two SPS units in HA mode.
Installing the SPS hardware
The following describes how to install a single SPS unit.
To install a single SPS unit
1. Unpack SPS.
2. (Optional) Install SPS into a rack with the slide rails. Slide rails are available for all
SPS appliances.
3. Connect the cables.
a. Connect the Ethernet cable facing your LAN to the Ethernet connector labeled
as 1. This is physical interface 1 of SPS. This interface is used for the initial
configuration of SPS, and for monitoring connections. (For details on the
roles of the different interfaces, see "Network interfaces" in the
Administration Guide.)
One Identity Safeguard for
One Identity Safeguard for Privileged Sessions Hardware Installation Guide
Installation Guide
SPS 6.0 Installation Guide
4
8
Advertisement
Table of Contents
