VTech Go! Go! Smart Wheels Press & Race SmartPoint Vehicle Parents' Manual

Go! Go! Smart Wheels
®
SmartPoint Vehicle Parent's Guide
BATTERY INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of the
unit. Use a screwdriver to loosen the screw.
3. Install 1 new AAA (AM-4/LR03) battery
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
WARNING: All packing materials such as tape, plastic sheets,
packaging locks, removable tags, cable ties and
packaging screws are not part of this toy, and should
be discarded for your child's safety.
NOTE:
Please keep this parent's guide as it contains
important information.
ATTENTION: Pour la sécurité de votre enfant, débarrassez-vous
de tous les produits d'emballage tels que rubans
adhésifs, feuilles de plastique, attaches, étiquettes
et vis d'emballage. Ils ne font pas partie du jouet.
NOTE : Il est conseillé de conserver ce guide des parents car
il comporte des informations importantes.
Unlock the packaging locks:
Turn the packaging lock counter-
clockwise several times.
Pull out and discard the packaging lock.
1
® TM
Press & Race
91-003299-030
WARNING: For your child's safety, do not press and release the
vehicle on clothing, body or hair.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if removable).
• Rechargeable batteries are only to be charged under adult supervision.
PRODUCT FEATURES
1. ON/OFF SWITCH
To turn the unit On, slide the On/Off switch to
the On position. To turn the unit Off, slide
the On/Off switch to the Off position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech Go! Go! Smart Wheels
®
vehicle will automatically power down after approximately 60 seconds without
input. The vehicle can be turned on again by pressing the Action or Light-
Up buttons, pressing down on the vehicle, pushing the vehicle quickly or by
placing it on a SmartPoint
® location.
NOTE: This product is in Try-Me mode in the packaging. After opening the package,
2
Press & Race™
®