Connecting To An Antenna Or Cable; Remote Control; Other Connections - LG 32LW300C Easy Setup Manual

Connecting to an Antenna or Cable

Connect an antenna, cable, or cable box to watch TV while
referring to the following. The illustrations may differ
from the actual items and an RF cable is optional.
CAUTION
• Make sure not to bend the copper wire of the RF cable.
Copper wire
• Complete all connections between devices, and then
connect the power cord to the power outlet to prevent
damage to your TV.
NOTE
• To improve the picture quality in a poor signal area,
purchase a signal amplifier.
• Use a signal splitter to use 2 TVs or more.
• If the antenna is not installed properly, contact your
dealer for assistance.
• DTV Audio Supported Codec: MPEG, Dolby digital, AAC,
HE-AAC

Other Connections

Connect your TV to external devices. For the best picture
and audio quality, connect the external device and the TV
with the HDMI cable.
NOTE
• Use only with the 3 pole 3.5 mm stereo jack.
• Do not connect your headphones or earphones to the
port for connecting an external speaker.
• HDMI Audio Supported Format:
DTS (44.1 kHz / 48 kHz),
AC3 (32 kHz / 44.1 kHz / 48 kHz),
PCM (32 kHz / 44.1 kHz / 48 kHz / 96 kHz / 192 kHz)
(Depending upon model)
10

Remote Control

(Depending upon model)
The descriptions in this manual are based on the buttons
on the remote control. Please read this manual carefully
and use the TV correctly. To install batteries, open the
battery cover, replace batteries (1.5 V AAA) matching
the and ends to the label inside the compartment,
and close the battery cover. Failure to match the correct
polarities of the battery may cause the battery to burst or
leak, resulting in fire, personal injury, or ambient pollution.
To remove the batteries, perform the installation actions
in reverse. This remote uses infrared light. When in use,
it should be pointed in the direction of the TV's remote
sensor.
2
3
A
(Power) Turns the TV on or off.
1
Returns to the last TV channel.
(Depending upon model)
1
Toggles between Radio, TV, CATV and
DTV. (Depending upon model)
2
Activates or deactivates the subtitles.
(Depending upon model)
2
Recalls your preferred subtitle in digital
mode. (Depending upon model)
Selects an AV mode.
Resizes an image.
Changes the input source.
Number button Enters numbers.
3
(Dash) Inserts a dash between numbers such as
2-1 and 2-2. (Depending upon model)
3
Accesses the saved channel list.
Alternates between the two last channels
selected (pressing repeatedly).
1
A