Related Manuals for Toro 22549
Summary of Contents for Toro 22549
- Page 1 Form No. 3429-979 Rev C Adjustable Forks TXL 2000 Tool Carrier or Outcross 9060 Series Traction Unit Model No. 22549—Serial No. 318000001 and Up *3429-979* C Register at www.Toro.com. Original Instructions (EN)
- Page 2 Figure 1 1. Model and serial number location The adjustable forks attachment is a load-bearing attachment intended to be used on a Toro tool carrier or multipurpose machine. It is designed primarily for moving material such as posts, rocks, trees, pallets, Model No.
-
Page 3: Table Of Contents
Contents Safety Safety ............... 3 General Safety General Safety ........... 3 Slope Safety ............4 Always follow all safety instructions to avoid serious Forks Safety ............4 injury or death. Maintenance and Storage Safety......4 • Safety and Instructional Decals ......5 Do not transport an attachment with the arms raised or extended;... -
Page 4: Slope Safety
Slope Safety • Use caution when operating the machine near the following: • Operate the machine up and down slopes with – Drop-offs the heavy end of the machine uphill. Weight distribution changes with attachments. An empty – Ditches load-bearing attachment makes the rear of the –... -
Page 5: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal125-6110 125-6110 1. Crushing hazard—do not stand under any part of the machine. -
Page 6: Setup
Loader arms extended 335 kg (745 lb) To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the... -
Page 7: Operation
Operation Determine the left and right sides of the machine from the normal operating position. Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. g272288 Important: Before installing the attachment, Figure 5 position the machine on a level surface, ensure that the mount plates are free of any dirt or debris,... -
Page 8: Operating Tips
Operating Tips Storage • To adjust the forks, slide them along the frame to Before long-term storage, wash the attachment the desired width. Adjust the forks to the widest with mild detergent and water to remove dirt and possible setting to ensure that the load is as stable grime. - Page 9 Notes:...
- Page 10 Notes:...
- Page 11 Notes:...
- Page 12 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.