Installation; Unloading/Transport Within The Building Site; Lifting Using A Forklift Truck; Lifting Using A Crane - Swegon COOL DX Series Installation And Maintenance Instructions Manual

3

INSTALLATION

3.1 Unloading/transport
within the building site
Important!
All transport should be carried out with the cooling unit
in the horizontal position.

3.1.1 Lifting using a forklift truck

Warning
The unit has a high centre of gravity! Carefully lift the
cooling unit!
6 www.swegon.com

3.1.2 Lifting using a crane

Position two line spreaders at the upper side of the cooling
unit and two under the underside of the pallet or under
the cooling unit and lift in the pallet (or in the base frame
of the cooling unit if the unit is not delivered on a pallet.
See sketch
3.1.3 Lifting eye bolts (not COOL DX Top)
The COOL DX Top can be lifted using the four lifting eye
bolts located in the cooling unit's duct connections (see
illustration). Remove the lifting eye bolts after you've lifted
the cooling unit into position.

3.2 Arrangement

Place the COOL DX/COOL DX Top at a suitable location.
Allow an open space around the safety isolating switch/
mains power switch for servicing in accordance with appli-
cable electrical safety regulations.
The unit can be positioned with its backside against a wall;
however it is advisable to position it at a distance of ap-
prox. 1 metre away from a wall to make it easier to service
the rear compressor.
We reserve the right to alter specifications.
GB.COOLDX.IN.E.130821