Husqvarna 324L Operator's Manual page 17

2. Remove the air filter cover and remove the air filter.
3. Clean the air filter with warm soap water.
4. Clean the inner surface of the air filter cover. Use air
or a brush.
5. Do a check of the surface of the rubber seal.
Replace the filter on the rubber seal if it is damaged.
6. Make sure that the filter is dry before you install it.
To apply oil to the foam air filter
CAUTION: Always use Husqvarna special
air filter oil. Do not use other types of oil.
WARNING: Put on protective gloves. The air
filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
4. Push the unwanted oil out of the foam air filter while
in the plastic bag.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
1323 - 002 - 08.07.2020
Bevel gear
The bevel gear is filled to ¾ with grease at the factory.
Before you use the product, make sure that the grease
level has not changed. Use Husqvarna special grease if
it is necessary to fill up. Do not replace the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.
Maintenance schedule
The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
Maintenance on page 14
described in
Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
Daily Weekly Monthly
X
X
X
X
X
17