Table of Contents
Advertisement
The Night Scan Spot is equipped with a flashing alert feature which can be used:
To warn approaching motorists of pedestrians of potential hazards
To alert that help is needed
With service vehicles to alter on-coming vehicles that there are people at work
The Stow Feature causes the light to automatically turn to face the forward position when turned
off. If power is removed from the Night Scan Spot while it is still on, the light will automatically
turn to face the forward position after it is turned back on with power restored.
Section 2
This section describes the installation of the Mast System and provides general procedures that
must be followed to ensure a successful installation. Use care to understand and follow all
precautions while installing.
2.1 Installation Safety Precautions
Connect the LED light to a 12 or 24 volt DC power source. Ensure an appropriate sized circuit
protection device is installed (circuit breaker or fuse). See Specifications (Section 1.3).
2.2 Installation Procedures
To install the Night Scan Spot:
1. Select a suitable mounting location.
2. Move the Night Scan Spot into place in the mounting location.
3. Ensure the Night Scan Spot is level in all directions. If necessary, shims may be added
to correct the alignment.
4. Use the Night Scan Spot as a template to drill four holes in the desired mounting
location. Ensure the Night Scan Spot remains level during drilling.
5. Secure the Night Scan Spot in position using all four mounting holes with customer-
provided stainless steel hardware. The mounting hardware must include proper means
to resist vibration loosening such as thread-locking compound or locking hardware.
Torque all hardware as appropriate for its size and grade.
6. Move the Remote Control Holder into place in the mounting location.
7. Use the Remote Control Holder as a template to drill two holes in the desired mounting
location.
TP-5590101-00
June 2019
Installation
N
S
S
O
IGHT
CAN
POT
PERATOR
'
M
S
ANUAL
3
Advertisement
Table of Contents
