Table of Contents
Advertisement
4. In the start window of the receiver display:
Check accuracy of the
sensor connection. If a
«no sensor» symbol
is lit on the display, check
if the sensor is connected
correctly.
Check the charge status of the batteries the charge
should be no less than 4,0 V). If the battery charge is low,
replace the batteries.
4.2 Conduct receiver setup
1.
Switch on the
measurement mode
using the button
Using buttons ◄/►, set
3.
the desired frequency in the
filtration zone
for example, 50 Hz
6.
Set an acceptable volume
using ◄/►
level volume
buttons
,
2.
To select the necessary
frequency press the frequency
button
. symbol will appear
4.
Leave the filter adjustment
mode by pressing the frequency
button
will appear in the volume
adjustment zone
7. Moving along the route,
it is necessary to move the
electromagnetic sensor across
the route in one and the other side
to maintain a maximal level of the
signal.
display backlighting, using ◄/► buttons
Fig. 4.2
. Indicator
6
Check the received signal type
as «continuous»
buttons ▲/▼)
If it necessary, change the
frequency of the second filter
by changing the number of
harmonic component «f
another by buttons
Set the necessary level of receiver
For tracing of energized
cables please set
frequency 50 Hz.
5.
Set input signal level using
sensitivity buttons
Level (at the bottom of the scale)
must be within 50 ... 90% of the
maximum
Attention! input overload can lead
to the wrong interpretation of data
(by any of
» to
HRM
№2
or
.
and
Advertisement
Table of Contents
