Table of Contents
Advertisement
OPERATION
TROUBLESHOOTING
PROBLEM
Electronic control fails to operate.
Motor will not stop/ only some functions on
the electronic control pad are working.
Excessive noise from blower.
Blower runs but no air comes out through
the jets
Air outlets in jet heads are blocked.
SOLUTION
• Check the electrical power supply. Reset circuit or replace fuse if necessary.
• Check Ground Fault Circuit Interrupter (GFCI). Reset if tripped.
• If the system has been in operation for a long time it is possible that the thermal protection switch has shut off the motor. Turn off the system and wait 30
minutes for it to cool, then try again.
• Check the connections between the blower and the control module.
• When the circuit breaker is reset or when there is a power failure, synchronize the command with the module.
• Let the keyboard dry and check if the problem persists.
• Most of the noise from your Rouge-Air or Mass-Air system actually comes from the movement of the water.
• Check that the blower is firmly secured.
• Make certain that there are no obstructions close to the intake of the blower, and that it has an adequate supply of fresh air.
• Check that the main air hose from the blower to the manifold is properly connected. Reconnect and tighten clamps if necessary.
• If the air outlets of a jet head are obstructed with soap or other residues, fill the tub with water and brush them gently with a toothbrush. Turn the system
ON then OFF several times.
• Remove caps (Mass-Air & Rouge-Air) and ball bearing and clean with cotton swabs. Use a rubber head hammer for reinstallation.
• If the problem persists tap the jet heads with a spoon while the blower is running (Mass-Air system only).
p.7
Advertisement
Table of Contents
Troubleshooting
