Lubricating The Wheel Gears - Toro Super Recycler 21382 Operator's Manual

Figure 27
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
10. Read the oil level on the dipstick; refer to
Checking the Engine-Oil Level (page
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Lubricating the Wheel
Gears
Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear
wheels with a clean rag
g017475
1. Grease fitting
2. Install a grease gun onto each fitting and gently
apply 2 or 3 pumps of No. 2 lithium grease.
11).
22
(Figure 28).
Figure 28
g003234