Advertisement
5.6.3.
Turn the handle, fig.2.3, anticlockwise to move the cutting bit towards the workpiece.
5.6.4.
Start feeding slowly, with not too much force, to prevent overloading the drill.
caUTiOn! Prepare for bursting through the workpiece.
5.6.5.
If the drill suddenly stops, you must turn off the motor switch immediately.
5.6.6.
once the hole has been cut, back the cutting head back out of the hole and switch off the motor.
5.6.7.
Turn off the coolant tap.
5.6.8.
Remove the debris from the cutting head.
5.6.9.
Clean away swarf.
5.6.10.
Undo the safety strap.
5.6.11.
Support the weight of the drill and turn off the magnet. Remove the cutting bit and replace drill in its case.
5.7.
ADJUSTING THE SLIDES Refer to fig.2.5
WaRning! disconnect from mains supply before performing any adjustments.
‰
5.7.1.
To adjust the friction on the drill slide mechanism, remove the drill cutter.
5.7.2.
Loosen the 5 slide locknuts and adjust the 2.5mm grub screws until the required amount of friction on the slides has been achieved.
5.7.3.
Tighten the locknuts and test before using the drill.
5.8.
REPLACING THE FUSE Refer to fig.2.4
5.8.1.
Undo the fuse cover and replace fuse with one of same rating.
6. MainTenance
WaRning! disconnect from mains supply before performing any maintenance.
‰
6.1.
Remove the cut 'plug' from the cutter, each time it is used.
6.2.
Keep the tool clean.
6.3.
Store in a dry, childproof location in its case.
Weee RegULaTiOnS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
enviROnMenT PROTecTiOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey group, Kempson Way, Suffolk business Park, bury St edmunds, Suffolk. iP32 7aR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
mAG230V | Issue:1 18/12/18
Advertisement
