Table of Contents
Advertisement
ColorFlat7 RGB
ColorFlat7 RGB
Troubleshooting
Symptom
Fixture Auto-
Shut Off
Beam is Dim
No Light Output
Chase Speed
Too Fast/Slow
No Power
Blown Fuse
Slow Movement
No Response to
Audio
Fixture Not
Responding /
Responding
Erratically
Intermittent
Lamp
Remote Doesn't
Work
Fixture Moving
On Its Own
wdmlighting.com | 4106 Harry Hines Blvd, Dallas, Texas 75219 | 800-893-9787
Solution
Check the fan in the fixture. If it is stopped or moving
slower than normal, the unit may have shut itself off due to
high heat. This is to protect the fixture from overheating.
Clear the fan of obstructions, or return the unit for service.
Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable. Contact service
for more information.
Check to ensure proper setup of speed adjustment.
Check fuse, AC cord and circuit for malfunction.
Check AC cord and circuit for damage, verify that moving
parts are not restricted and that unit's ventilation is not
obstructed
Verify that 220V/110V switch is in the correct position, if
applicable. Also check that speed channels are set
appropriately.
Verify that the fixture is in "Sound Active" mode.
Adjust Audio Sensitivity, If Applicable.
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Check lamp for properly installation.
Re-lamp, lamp may have reached end of life.
Verify remote control cable is installed properly and securely.
Verify remote is correct type (CA-9 or other as applicable.)
Verify proper mode of operation. Is the fixture in "Auto"
mode?
Advertisement
Table of Contents
