Table of Contents
Advertisement
ColorFlat7 RGB
ColorFlat7 RGB
4. OPERATING ADJUSTMENTS
NOTE: After making any adjustment, the fixture will return to the correct mode
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as Addr on the
LED Readout. Use the <ENTER> button then the <UP> and <DOWN>
buttons to
choose a channel between 1 and 512. Press <ENTER> again to confirm.
2.) To change between 3 and 6 channel DMX mode, select ChNd, then press
<ENTER>. Select either 6Ch or 3Ch, then press <ENTER> again to con-
firm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX
con- nector on the rear of the units. It may be necessary to use a
terminator at the last fixture. For more information about terminators, see
page 8.
2.) Choose a unit to function as the Master. Select MAST. The master unit
must be the first unit. Finally, chain the units together using DMX cable.
Master
3.) Select slave function by using the <UP>/<DOWN> keys to reach
SLAV in the Master/Auto menu on the slave units, and they will react in the
same as the Master.
Slave
4.) On the master fixture, use the <UP>/<DOWN> keys to reach SHND,
which allows you to select the Master/Slave mode.
Sound active
CoLo
Auto
CoLo
mode
Color
preset
To set a custom color in Master/Slave / Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green and Blue
values
from 0-255. You can also use this function to adjust the overall white balance of
the fix- ture while running in any mode.
Please note that modifying the values in this step will affect ALL modes,
therefore we recommend resetting all levels to their highest value (255)
after using this mode.
1.) Select NAnu from the control panel, then hit <ENTER>.
2.) Choose rEd, GrEE or bLuE, then hit <ENTER> to confirm.
3.) Using the <UP>/<DOWN> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER>
to confirm each color choice.
4.) Select Color preset mode as instructed above, then select CoL 7. then
<ENTER> to confirm.
To Show the Fixture Running Hours:
1.) Select FhrS from the control panel, then hit <ENTER> to confirm.
ColorFlat 7 RGBW/RGBW
wdmlighting.com | 4106 Harry Hines Blvd, Dallas, Texas 75219 | 800-893-9787
ColorFlat 7 RGBW/RGBW
Rev. A
after approximately 5 seconds.
SLNd then
NASt
SLNd then
SLAu to confirm.
SoUn then <ENTER> to confirm.
Auto, then <ENTER> to
then
confirm.
CoL 1 - CoL 7, <ENTER>.
then
Page 8
to confirm.
Copyright (c) 2011 Blizzard Lighting, LLC
Advertisement
Table of Contents
