Intended Use; Assembly And Operation; Maintenance - Worx WG512 Manual

OPERATION

INTENDED USE

The blower & vacuum is intended for residential use
only. Use the blower outdoors to move or vacuum
yard debris as needed.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the Blower/Vacuum
Tube
Attaching/Removing the Leaf
Collection Bag (vacuum mode
only)
Attaching the Shoulder Strap
(supplied with WG514 & WG522
only)
OPERATION
Converting from Vacuum to Blower
NOTE: Press either (a) or (b)
release button to turn the blower/
vacuum selector knob until the
knob clicks in place and is aligned
with the corresponding arrow
marking on the machine.
Converting from Blower to Vacuum
NOTE: Press either (a) or (b)
release button to turn the blower/
vacuum selector knob until the
knob clicks in place and is aligned
with the corresponding arrow
marking on the machine.
Attaching the Extension Cord
Starting & Stopping
WARNING:
-The tool runs for a few seconds
after it has been switched off. Let
the motor come to a complete
standstill before setting the tool
down.
Multiple Speed Adjustments
• Two-speed Adjustment
Note:
-To maximum vacuum
performance, it is better to use the
II mode.
- The I mode is only recommended
when vacuuming in sensitive areas
(i.e. flower beds)
12 AMP 3-in-1 Blow/Vac/Mulch
Using the Blower
CAUTION!
—For maximum vacuum
performance, it is better to use the
II high speed mode.
—Do not operate the blower near
bystanders or pets.
—Use extra care when cleaning
debris from stairs or other tight
FIGURE
areas.
—Wear safety goggles or other
suitable eye protection, long pants
and shoes.
See Fig. A
Using the Vacuum
WARNING:
See Fig. B1,
—For vacuuming, make sure
B2
the tube and bag are installed in
position, or else the machine can
See Fig. C1,
not start.
C2
CAUTION!
—Do not vacuum solid objects
such as carpentry wood blocks,
large branches, broken glass, or
pieces of metal and stones.
See Fig. D1,
D2
Emptying the Leaf Collection Bag
NOTE:
It is recommended to empty the
collection bag contents when the
bag is 75% full.
See Fig. D3,
D4
-Normal usage of the Debris
Collection bag causes it to wear
and deteriorate over time. A worn
or deteriorated bag allows small
objects to be thrown through
the bag, possibly injuring the
See Fig. E
operator or bystanders. Check
the bag frequently. If it is worn or
See Fig. F
deteriorated, replace it with a new
WORX debris collection bag.
Removing Clogged Debris from
the Impeller and Blade (Tool Not
Supplied)
Note: 1. Covert the tool from
vacuum mode to blower mode
before cleaning.
2. Remove the plug before opening
the debris cover.
See Fig. G

MAINTENANCE

Remove the plug before carrying out any adjustment,
servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Keep the
WARNING:
See Fig. G
See Fig. H
See Fig.
I1, I2
11
See Fig. J1,
J2
EN