LG LB-C186HSA2 Installation Manual page 14

Installation of Indoor, Outdoor Unit
WIERED REMOTE CONTROLLER INSTALLATION
• Since the room temperature sensor is in the remote controller, the remote controller box
should be installed in a place away from direct sunlight, high humidity and direct supply of cold
air to maintain proper space temperature.
Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of
the remote controller LED's, the remote controller should be installed properly as shown in
Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
14 Ceiling Duct Type Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
N
TIO
B FU NC t
SU hea
D r Pre mid r ify
EE He ate t Hu t doo
N SP O AUT De fros Ou
FA er 3 4
MP HI JET Filt 2
T TE p MED 1
SE m Tem
Roo LO NE 23
IO N ZO 21
ER AT 19
OP e 17
Ti m
SW ING set 15
TO gra m 13
AU Pro 11
09
t
tion uni 07
era 05
Op 03
m er f 01
Ti Of e
On no. Tim
Set
no
Fig.1 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
(1.5meters)