Canton Smart Amp 5.1 Short Manual page 37

Attention:
• Changes in the speaker type settings must be confirmed by pressing the „OK"
button to apply.
Now go back one level by pressing the „M" button, select the item „Speaker
5
Mapping" [SPM]
Select the appropriate speaker (Front, Center, Sub, etc.) and press „OK".
6
• If you connect passive speakers by cable, select Analog 1 to Analog 6 and exit
the submenu by pressing the „OK" button.
• If you have selected Smart speaker in the Speaker Config menu [SPC],
pressing the „OK" button will guide you to the connection process.
appears on the TV screen and the LED display shows [PIR].
in Process"
After „Paring in Process" appears on the TV screen, plug the power cord of the
7
(new) loudspeaker to be connected into the wall socket and switch it on
(if present) using the power switch.
About 10 - 20 sec. after turning on the speaker, the displays should show [CON].
8
Note:
• Before connecting Canton Smart speakers wireless to the Amp 5.1, make sure
that the Smart speaker to be connected is not connected to the power supply.
and press „OK".
English
„Paring
3 3 7