Registering Magic Remote Control; Troubleshooting - LG 43UM6900PUA Owner's Manual

Registering Magic Remote Control

How to register the Magic Remote Control
To use the Magic Remote, first pair it with your TV.
1 P ut batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
the remote control.
* I f the TV fails to register the Magic Remote, try again after turning
the TV off and back on.
How to deregister the Magic Remote Control
Press the (BACK) and
five seconds, to unpair the Magic Remote with your TV.
* P ressing and holding the
re-register Magic Remote at the same time.
• Do not mix new batteries with old batteries. This may
cause the batteries to overheat and leak.
• Failure to match the correct polarities of the battery
may cause the battery to burst or leak, resulting in fire,
personal injury, or ambient pollution.
• This apparatus uses batteries. In your community there
might be regulations that require you to dispose of these
batteries properly due to environmental considerations.
Please contact your local authorities for disposal or
recycling information.
• Batteries inside or inside the product shall not be exposed
to excessive heat such as sunshine, fire or the like.
12
Wheel (OK) on
(HOME) buttons at the same time, for
button will let you cancel and
User Guide
For more information about this TV, read the USER GUIDE embedded in
the product.
• To open the USER GUIDE →
This TV] → [User Guide]

Troubleshooting

Cannot control the TV with the remote control.
• Check if anything such as tape has been placed over the receiver.
• Check if there is any obstacle between the product and the remote
control.
• Replace the batteries with new fresh ones.
No image display and no sound is produced.
• Check if the product is turned on.
• Check if the power cord is connected to a wall outlet.
• Check if there is a problem in the wall outlet by connecting other
products.
The TV turns off suddenly.
• Check the power control settings. The power supply may be
interrupted.
• Check if the auto-off function is activated in the settings menu.
• If there is no signal while the TV is on, the TV will turn off
automatically after 15 minutes of inactivity.
( ) → [General] → [About