Power Supply Port; Usb Charge Unit With Blue Led - Sym CRUiSYM Owner's Manual

CAUTION:
 Automatic Lighting Connections are powered by battery, and therefore be aware of keeping main
switch on "ON" will run out of the battery in the condition without running the engine.
 PASS Switch
Turn ignition switch "ON" and press this button down. Then, the high beam of headlight will come on
immediately to warn the driver of the vehicle ahead that you intend to overtake him/her. (For overtaking,
high beam indicator will be used at this time.) This button will return to original position after releasing.
Turn Signal Switch

Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to "ON", and slide the turn signal switch to left or right.
Then, the turn signal lights will flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
 Horn Switch
Press this button down when ignition switch is in the "ON" position, the horn will sound.
CAUTION:
Do not press this button when you are in the area where is no honking allowed.


POWER SUPPLY PORT

The power supply port is inside the right front glove box. You can use the accessory socket to power a
trouble light, spotlight, radio, or cell phone,
1. Rated voltage: DC 12V
2. Control voltage scope: DC9V~16V

USB CHARGE UNIT with BLUE LED

1.Switching output voltage:DC5V±5%, DC9V±5%, DC12V±5%
with luminous blue LED.
2. Switching output current:2.0A, 1.5A, 1.0A
3. Overloading short circuit protection:>
4. Support BC1.2&QC2.0, DC5V/ DC9V/ DC12V
CAUTION:
 Do not plug in any head-generating accessory such as an automobile cigarette lighter because it will
damage the socket.
 Do not use the socket in raining day.
 Do not splash water or other liquid on socket when using the socket.
 To avoid not letting the vehicle run out of battery, and cannot start the engine. When you use the
power supply port or USB charger to output the current, remember to turn the ignition switch "ON"
and run the engine at the same time.
 The accessory socket's rated capacity is DC 12V, Max 120Watts (10A) and below long-term usage
4 hours.
etc.(DC12V, 10A120W)
Rubber dust cover
2.4±10A%
USB charge unit
11
7 . Use of each component
Power supply port