Table of Contents
Advertisement
Changing to NAT/Route mode
Changing to NAT/Route mode
Restarting the FortiGate unit
Shutting down the FortiGate unit
66
5
To reconnect to the web-based manager, connect to the interface configured for
Transparent mode management access and browse to https:// followed by the
Transparent mode management IP address.
By default in Transparent mode, you can connect to the internal interface. The default
Transparent mode management IP address is 10.10.10.1.
Use the following procedure to switch the FortiGate unit from Transparent mode to
NAT/Route mode. When the FortiGate unit has changed to NAT/Route mode its
configuration resets to NAT/Route mode factory defaults.
1
Go to System > Status.
2
Select Change to NAT Mode.
3
Select NAT/Route in the operation mode list.
4
Select OK.
The FortiGate unit changes operation mode.
5
To reconnect to the web-based manager you must connect to the interface configured
by default for management access.
By default in NAT/Route mode, you can connect to the internal interface. The default
Transparent mode management IP address is 192.168.1.99.
See
"Connecting to the web-based manager" on page 20
command line interface (CLI)" on page
1
Go to System > Status.
2
Select Restart.
The FortiGate unit restarts.
1
Go to System > Status.
2
Select Shutdown.
The FortiGate unit shuts down and all traffic flow stops.
The FortiGate unit can only be restarted after shutdown by turning the power off, then
on.
or
"Connecting to the
21.
System status
Fortinet Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the FortiGate FortiGate-50R and is the answer not in the manual?
Questions and answers