Advertisement
Marquee™ Bridge
Quick Start Guide
Figure 3 – Attaching the Marquee Bridge Outdoor
Unit to the Pole Mount Bracket
Figure 4a – Latching Bracket to Pole Mount
Figure 4b – Securing the Latches to the Pole Mount
Bracket
Aug
2004
PRELIMINARY
3.
Ensuring that there is no DC power applied to the
DC Power Injector, plug the round connector of the
outdoor Ethernet cable into the rear jack of the unit
(Fig. 5a for an MB-INT, or Fig. 5b for an MB-EXT),
making sure the notch is correctly aligned with the
tab on the jack as shown in Figure 6, then turn the
round locking nut clockwise as you push in until it
securely fastens onto the jack.
WARNING:
is properly plugged into the rear jack of the antenna
prior to connecting DC power because it is possible
to push it in the wrong way if enough force is used.
If DC Power is applied while you are attempting to
insert the round connector into the jack, it is
possible that, as you rotate the plug in an effort to
find the key, DC power pins will momentarily touch
the Ethernet pins. If this happens the Ethernet
circuitry on the board will be damaged. Any
harm caused by this action will not be covered by
the factory warranty and will be a billable repair.
Figure 5a – Connecting the Outdoor Ethernet Cable
Plug Round Connector of the
Outdoor Ethernet Cable Here
Figure 5b – Connecting the Outdoor Ethernet Cable
Plug Round Connector of the
Outdoor Ethernet Cable Here
2
Please verify that the round connector
to an MB-INT
to an MB-EXT
MNL-500265-001 – Rev ED4
Advertisement
