Fortigate-5001A Mounting Components - Fortinet FortiGate FortiGate-5001A Security System Manual

FortiGate-5001A mounting components

FortiGate-5001A mounting components
12
To install a FortiGate-5001A board you slide the board into an open slot in the
front of an ATCA chassis and then use the mounting components to lock the
board into place in the slot. When locked into place and positioned correctly the
board front panel is flush with the chassis front panel. The board is also connected
to the chassis backplane.
To position the board correctly you must use the mounting components shown in
Figure 6 for the right side of the front panel and
front panel.
Figure 6: FortiGate-5001A mounting components (right handle)
Retention
Lock
Handle
Hook
(right handle
only)
Lock
Handle
Note: The right handle includes a hook that secures the handle into place when the board
is mounted in the chassis (Figure
Otherwise the left and right mounting components are the same. Operating the left and
right handles is also basically the same except that without the hook you do not have to
squeeze the left handle lock. Also the left handle does not lock into place in the same way
as the right handle.
Figure 7: FortiGate-5001A mounting components (left handle)
Alignment
Pin
Retention
Lock
Screw
Handle
Figure 7
Closed
Alignment
Pin
Screw
Lock
Open
Alignment
Pin
Handle
Retention
Screw
Hook
(right handle
only)
6). The hook is not included on the left handle
AMC Slot
Filler
FortiGate-5001A Security System Guide
Hardware installation
for the left side of the
Alignment Pin
Retention
Screw
Handle
Alignment Pin
Retention
Screw
Lock
(Figure 7).
01-30000-0438-200800801