KAR-TECH MNTA1 MINI REMOTE User Manual

Mini remote control system preliminary

Advertisement

TM
MNTA1 MINI REMOTE
MINI REMOTE CONTROL SYSTEM
PRELIMINARY
USER MANUAL
March 07, 2006

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MNTA1 MINI REMOTE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KAR-TECH MNTA1 MINI REMOTE

  • Page 1 MNTA1 MINI REMOTE MINI REMOTE CONTROL SYSTEM PRELIMINARY USER MANUAL March 07, 2006...
  • Page 2: Table Of Contents

    MINI REMOTE INDEX Description ..............1 Installation ..............2 Before applying power ............. 2 Routine Maintenance ............3 Maintenance precautions ..........3 Troubleshooting ............. 3 Troubleshooting chart ..........4 Specifications ..............5 Instructions to the User ............ 6...
  • Page 3: Description

    MINI REMOTE DESCRIPTION: Controller) sold separately. KAR-TECH's MINI REMOTE is a state Each transmitter of the art microprocessor based preprogrammed with a special Radio Frequency (RF) remote radio ID code. The receiver is control system designed programmed to respond only to...
  • Page 4: Installation

    MINI REMOTE INSTALLATION: “Contains Module FCC ID:P4U- MNTA1” 1.Refer to the wiring chart for This is a requirement for any wiring connections. unit that contains this module must done. 3.When installing the unit, the exceptions can be made. main power should run from the battery, through a 20 amps fast blow fuse, to a power switch or BEFORE APPLYING POWER:...
  • Page 5: Routine Maintenance

    4. Inspect all connections for instructions, the system still looseness or corrosion. Tighten does not function, check the and/or "seal" as necessary. hydraulic system then contact your KAR-TECH representative further instructions MAINTENANCE PRECAUTIONS: servicing. When performing any inspection or maintenance work on the...
  • Page 6: Troubleshooting Chart

    MINI REMOTE TROUBLE SHOOTING CHART PROBLEM SOLUTION 1. No operation of all functions when a 1. Check to see if a selector switch is in the function switch is activated. proper position. 2. Check that unit power is on. 3. Check that receiver power is on. 4.
  • Page 7: Specifications

    The information, specifications, and illustrations in this manual are those in effect at the time of printing. KAR-TECH reserves the right to change specifications or design at any time without notice.
  • Page 8: Instructions To The User

    MINI REMOTE INSTRUCTION TO THE USER: This unit has been tested with part 15 of the FCC Rules. Any and found to comply changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

Table of Contents