Operation; Starting Up The Projector - BenQ Home Cinema Series User Manual

Operation

Starting up the projector

1. Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch
(where fitted). Check that the
indicator light
after power has been applied.
Please use the original accessories (e.g. power cable) only
with the device to avoid possible dangers such as electric
shock and fire.
2. Press
control
indicator light
The fans starts operating, and a start-up image display on the screen while it warms
up. The projector does not respond to further commands whiles it is warm up.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
3. If this is the first time you turn on the projector, the setup wizard appears to guide
you through setting up the projector. If you have already done this, skip this step and
move on to step 5.
• Use the arrow keys (
through the menu items.
• Use O K to confirm the selected menu item.
T he Setup W izard screenshots below are for reference only and may differ from the actual
design.
i. Specify
on the projector lights orange
PO W ER
on the projector
to start the projector and a start up tone sounds. The
flashes green and stays green when the projector is on.
"Power O n/O ff Ring Tone" on page 56
▲
Projector Position
For more information about
projector position, see
location" on page 16.
POW ER
or remote
▼ ◄ ►
/ / / ) on the projector or remote control to move
.
"Choosing a
POW ER
for details.
O peration 27