Bosch HBG5585 0B Series Instruction Manual page 24

Rails
en
Keep the "PUSH" tab pushed back and swing the rail
2.
out (fig. ).
"
Pull the rail out towards you until the retainer at the
3.
back unhooks (fig.
#
Remove the pull-out rail (fig.
4.
Use washing-up liquid and a sponge to clean the pull-
out rails. For stubborn dirt deposits, use a brush.
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
The rail must sit between the two bars (fig.
1.
24
).
).
$
!
Push the retainer at the back in between the lower
2.
and the upper bar (fig.
Push on the "PUSH" tab and swing the rail in so that
3.
the retainer ends up between the two bars (fig.
Release the "PUSH" tab; the retainer will hook into
4.
place (fig.
and slide it back in.
).
).
"
). Then pull the rail out as far as it will go
$
).
#