Exhaust Screen Service; Battery Maintenance - Simplicity 1693452 Operator's Manual

EXHAUST SCREEN SERVICE

WARNING
Always allow the engine to cool before beginning
any service work were the muffler or exhaust
components must be handled. Wear gloves when
handling exhaust components.
Service Interval: Every 50 Hours
Inspect, clean or replace the exhaust screen after every
50 hours of operation.
1. Park the tractor on a level surface. Disengage the
PTO, turn off the engine and set the parking brake.
Remove the key. Allow the engine and muffler to
cool.
2. Remove the screw (B, Figure 16). Using a pair of pli-
ers, remove the exhaust screen (A).
3. Inspect the screen. Shake any particles from the
screen. If necessary, clean the screen with a wire
brush and safety solvent. Reinstall the screen or if it
is excessively dirty or damaged, replace it.

BATTERY MAINTENANCE

WARNING
Be careful when handling the battery. Avoid
spilling electrolyte. Keep flames and sparks away
from the battery.
When removing or installing battery cables,
disconnect the negative cable FIRST and reconnect
it LAST. If not done in this order, the positive
terminal can be shorted to the frame by a tool.
Checking the Battery Fluid
Service Interval: Every 100 Hours
1. Raise the seat to access battery compartment.
2. Remove the battery filler cap(s). Fluid must be even
with the split ring full mark (C, Figure 17). If not, add
distilled water.
3. Reinstall the filler cap(s).
Cleaning the Battery and Cables
Service Interval: Every 100 Hours
1. Disconnect the cables from the battery, negative
cable first (A, Figure 17).
2. Remove the battery from the battery compartment.
3. Clean the battery compartment with a solution of bak-
ing soda and water.
4. Clean the battery terminals and cable ends with a
wire brush and battery terminal cleaner until shiny.
5. Reinstall the battery in the battery compartment.
Hood Not Shown
for Clarity
A
Figure 16. Clean / Replace Exhaust Screen
A. Exhaust Screen
B. Screw
C
A
E
FRONT
Figure 17. Battery Cables & Fill
A. Negative Cable
B. Positive Cable & Cover
C. Split-Ring
D. Nut, Lockwasher, & Washer
E. Capscrew
6. Reattach the battery cables, positive cable first (B,
Figure 17).
7. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
21
Regular Maintenance
B
D
B
D