Ceiling Mounting - Security Tronix HD-COAXINATORTVI ST-HDC2PTZFM Quick Start Manual

2.2.3 Ceiling Mounting

Steps:
1. Rotate the lower dome counterclockwise to separate it from the back box. Refer to the Figure
2-1.
2. Remove the protective lens cover, foam and sticker from the dome drive.
3. Set the address and baudrate for the HDC-TVI speed dome. Please refer to the Section 1.2.1
5-inch Speed Dome Settings for DIP switch settings.
4. Attach lower dome to the back box, and rotate clockwise to secure it.
5. Use the mounting base as a template to mark four screw holes onto the ceiling.
6. If you route cables from the top of the back box, mark the cable hole on the ceiling and drill a
hole.
7. Secure the mounting base to the ceiling with set screws.
 If the speed dome is installed to a wooden wall, use the self-tapping screws to secure the
mounting base.
 If the dome is installed to the cement wall, drill three Φ5 mounting holes onto the wall
according to the hole locations, and then insert the cement screws into the holes and
finally use self-tapping screws to secure the mounting base to the wall.
ST-HDC2PTZFM·Quick Start Guide
Figure 2-9 Cabling for Ceiling Mounting
Figure 2-10 Mark the Screw Positions
18