Garmin StreetPilot c320 Quick Reference Manual page 3

Step 1: Configure Your c320
Press and hold the Power button
instructions to set up your c320. You only have to do this once.
Step 2: Install Software and Load Maps
Before using your c320, you need to install software on your computer using the DVD-
ROM. Then load maps on your c320. Refer to the Setup Guide for complete instructions.
Step 3: Mount Your c320
To ensure a tight grip, clean and dry your windshield.
Fit the bottom of your c320
into the cradle of the suction
cup mount.
Plug the cable into a receptacle in your vehicle. If necessary, use the tension knob to loosen
or tighten the tension in the mount to improve your viewing angle.
Your unit will turn on automatically if you have started your vehicle. To manually turn on
your c320, press and hold the Power button
WARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the c320
installed to place and secure the device so it will not interfere with the vehicle operating controls and safety
devices, obstruct the driver's view of driving conditions, or cause personal injury in the event of an accident.
on the side of the unit to turn it on. Follow the on-screen
Tilt your c320 back until
it snaps in place.
on the side of the unit.
1
Tension knob
Place the suction cup on the
windshield. Flip the lever back,
toward the windshield.
E
N