Fault Finding; The Machine Does Not Start Up; The Machine Stops; Abnormal Noise-Vibrations - SEMAK VB250 Operation And Warranty Booklet

FAULT FINDING

THE MACHINE DOES NOT START UP

Check the following points:
The machine is not properly plugged. Check if the plug is wrongly connected to the outlet.
There has been a cut of the power supply.

THE MACHINE STOPS

Check the following points:
There has been a cut. Stop and unplug the machine. Wait till the power comes back and restart the
machine up.
The motor is overloaded. Stop and unplug the machine and wait some minutes so that the motor
can cool off. After a cooling off period it can be turned on again.

ABNORMAL NOISE-VIBRATIONS

Check the following points:
Water has entered into the attachment. Dismount the parts following Point 5.2 and dry them next.
Sealing parts to avoid leaks (the joints and/or the oil seal) are damaged. If so, replace them.
The transmission parts (the shaft and the bushing) are damaged. If so, replace them.
WARNING!
If the problems persist, contact an Authorised After Sales Agent.

SAFETY REGULATIONS AND STANDARDS

This product has been manufactured in compliance with the Directives and the Standards in force in
the E.U. Protection Indices IP34.
The level of noise of the machine operating, placed 1,6 meter high and measured at a distance of 1
meter is:
76 dB (A), precision ±2 dB(A).
Background noise: 40 dB(A).
Semak Vitablend complies with the following electrical standards
Compliance CISPR 14
Page | 13