Ap Management - TP-Link AURANET CAP300-Outdoor User Manual

AP Management

You can change the IP address, mask, default gateway, web service port and web
session timeout of the CAP and enable the manage VLAN.
IP Address:
Mask:
Default Gateway:
Manage VLAN:
WEB Service
Port:
Figure 6-2 AP Management Page
Set the IP address through which the hosts in the LAN can visit the
CAP. The default setting is 192.168.0.254. You can change the IP
according to the network need.
Set the mask of CAP. The default setting is 255.255.255.0. You can
change it according to the network need.
Set the default gateway of CAP. The default setting is 255.255.255.0.
You can change it according to the network need.
Check the box to enable the manage VLAN. Specify the Manage
VLAN ID. The valid values are from 1 to 4094.
Manage VLAN provides a safer way for you to manage the CAPs.
With it enabled, only the hosts in the manage VLAN can log in to the
CAP's webpage. Since most hosts cannot process VLAN TAGs, you
should connect the management host to the network via a switch.
Configure VLAN settings for the switches on the network to ensure
the communication between the host and the CAP in the manage
VLAN.
Set the Web service port for the CAP.
22