Table of Contents
Advertisement
Disassembly
Removing the System Memory (RAM)
Figure 8
RAM Module
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
Removal
DDR3L Up to 1600 MHz. The main memory can be expanded up to 16GB. The SO-DIMM modules supported are
1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST routine once you
a. Remove the screws
turn on your computer.
from the component
bay cover.
Memory Upgrade Process
b. Remove the compo-
nent bay cover. The
1. Turn off the computer, turn it over, and remove the battery
RAM modules will be
2. Remove screws
visible at point
6
on
3. Lift the component bay cover
the mainboard.
lems using a finger to do this, then use a non-abrasive, non-sharp object (e.g. a coin) to lift the cover up before
removal).
4. The RAM modules will be visible at point
a.
Contact Warning
Be careful not to touch
the metal pins on the
module's
connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module's
performance.
3. Component Bay Cov-
er
• 2 Screws
2 - 12 Removing the System Memory (RAM)
-
from the component bay cover
1
2
off the computer case by applying pressure at points
3
6
5
4
1
2
3
(page 2 -
5).
(Figure
8a).
on the mainboard
(Figure 8b
)
.
b.
6
&
; if you have prob-
4
5
3
Hide quick links:
Advertisement
Table of Contents
