QUICK START GUIDE
The ice cube thickness is factory set for best overall
performance. The factory setting "0" is designed to
maintain an ice bridge of approximately 1/16" to 1/8"
(1.6 mm to 3.2 mm) under normal conditions, resulting in
a dimple of approximately 1/4" to 1/2" (6.4 mm to
12.7 mm) in depth. A fuller cube with less of a dimple
results in a thicker ice bridge. As the ice bridge thickens,
the tendency for the cubes to stay together as a slab
increases. A bridge thicker than 1/8" (3.2 mm) may cause
cubes to overfill the ice bucket.
32 ice cubes are formed on a 4 x 8 slab during each cycle.
Each cycle takes approximately 15-20 minutes at the
default cube thickness (0).
7/8"
(22 mm)
7/8"
(22 mm)
Your clear ice machine is pre-set to produce ice between
the optimal dimensions illustrated below:
Cube Details
1/4" TO 1/2"
(6.4 mm to 12.7 mm)
DIMPLE
Factory Default Setting - 0
DIMPLES
ICE BRIDGE
1/16" TO 1/8"
(1.6 mm to 3.2 mm)
ICE BRIDGE
THINNER BRIDGE
DEEPER DIMPLE
< 0
SETTING
ICE ADJUST
Up
Down
Adjust ice thickness as follows:
1. Press
and
Customer Menu.
2. Press
to select "Ice Adjust".
3. Press
. The selection will begin to flash.
4. Press
to make the ice thicker or
thinner. Press
to confirm your choice.
11
THICKER BRIDGE
SHALLOWER DIMPLE
> 0
SETTING
RETURN TO MENU
ICE ADJUST
ICE ADJUST = 0
and hold for 5 seconds to enter the
to make the ice
u-line.com
Select