Mini COOPER CONVERTIBLE Owner's Manual page 133

▷ When the driver applies the brakes.
▷ Manual transmission: when the clutch
pedal is depressed for a few seconds or re‐
leased while a gear is not engaged.
▷ If selector lever position N is set.
▷ When DTC is activated or DSC is deacti‐
vated.
▷ When DSC is actively controlling stability.
▷ If the detection range of the camera is im‐
paired, for instance by soiling, heavy pre‐
cipitation or glare effects from the sun.
▷ If the vehicle in front decelerates below a
speed of approx. 20 mph/30 km/h.
Setting the speed
Maintaining/storing the speed
Press or button in the interrupted state.
When the system is switched on, the current
speed is maintained and stored as the desired
speed.
The stored speed is displayed on the
symbol.
DSC will be switched on, if needed.
The speed can also be stored as follows:
Press button.
Changing the speed
or button: press until the desired speed
is set.
If active, the displayed speed is stored and the
vehicle reaches the stored speed when the
road is clear.
▷ or button: each time it is pressed to
the point of resistance, the desired speed
increases or decreases by approx.
1 mph/1 km/h.
▷ or button: each time it is pressed
past the point of resistance, the desired
Online Edition for Part no. 01 40 2 915 102 - X/16
Driving comfort
speed increases or decreases by a maxi‐
mum of 5 mph/10 km/h.
or button: hold down to repeat the ac‐
tion.
Adjusting distance
Safety information
WARNING
The system does not release from the
personal responsibility. Due to the system lim‐
its, braking can be late. There is a risk of acci‐
dents or risk of property damage. Be aware to
the traffic situation at all times. Adjust the dis‐
tance to the traffic and weather conditions and
maintain the prescribed safety distance, possi‐
bly by braking.◀
Reduce distance
Press button repeatedly until the de‐
sired distance is set.
The set distance is briefly displayed in
the left part of the instrument cluster.
Increase distance
Press button repeatedly until the de‐
sired distance is set.
The set distance is briefly displayed in
the left part of the instrument cluster.
Continuing cruise control
General information
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large before
calling up the stored speed. Otherwise, unin‐
tentional braking or accelerating may occur.
CONTROLS
133