Preparing The Mower For Storage; Folding The Handle; Removing The Mower From Storage - Toro 20792 Operator's Manual

Storage
Store the mower in a cool, clean, dry place.
Preparing the Mower for
Storage
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the mower in an enclosure near an
open flame.
•
Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Run the mower until the engine stops from running
out of fuel.
3. Prime the engine and start it again.
4. Allow the engine to run until it stops. When you can no
longer start the engine, it is sufficiently dry.
5. Remove the wire from the spark plug and connect the
wire onto the retaining post.
6. Remove the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder to
prevent cylinder corrosion during the off-season.
7. Loosely install the spark plug.
8. Tighten all nuts, bolts, and screws.

Folding the Handle

1. Remove the lower handle knobs (Figure 40).
Figure 40
Note: Attach the lower handle knobs onto the bolts in
the handle to prevent losing them.
2. Detach the lower handle brackets from the lower end of
both handle sides (Figure 40).
3. Rotate the handle forward (Figure 41).
Important: Route the cables to the outside of the
handle knobs as you fold the upper handle.
Figure 41
4. To unfold the handle, refer to Unfolding the Handle.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine rapidly using
the starter to blow the excess oil from the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N⋅m).
3. Connect the wire to the spark plug.
15