Premaintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro 74841 Operator's Manual

Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the
neutral lock position. Lift the seat forward.
The following components can be accessed by raising
the seat:
• Service decal
• Fuses
• Battery and cables

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove the
key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings (Figure 34 and Figure 34)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
1. Front caster tire
4. Connect a grease gun to each fitting (Figure 34 and
Figure 33). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
32
1
G009949
Figure 34